While functionally compatible with the implementation in ElementalIRCd, our approach is different,
specifically pre-calculating the bitmask at config load time. This is more efficient, and allows us
to report errors as part of the configuration phase.
This allows multiple improvements to m_sasl. With this change, the SASL
authentication gets aborted immediately when services are offline.
Additionally, we send the SASL ENCAP messages directly to the specified
SASL agent.
The code to send each channel mode only to servers supporting it was
broken a while ago and was not very useful anyway. Therefore, require
all connecting servers to support all standard channel modes.
There are IPv4 and IPv6 ranges reserved for documentation and example code;
use these to minimize the risk if someone accidentally uses an unmodified
example conf.
Add the flags (auth{} spoof, dynamic spoof) to struct Whowas and add a
show_ip_whowas().
Normal users now see IPs of unspoofed users, and remote opers can see IPs
behind dynamic spoofs. Also, general::hide_spoof_ips is now applied when
the IP is shown, not when the client exits.
This is to follow the precident set by Atheme's atheme.conf.example file. Since the ircd now fails to start on a non-existant configuration file, seeing that message would make one know where to look.
Add two mechanism for avoiding name-collisions in a system-wide
installation of charybdis. The ssld and bandb daemons, intended to be
directly used by ircd and not the user, install into libexec when
--enable-fhs-paths is set. For binaries which are meant to be in PATH
(bindir), such as ircd and viconf, there is now an option
--with-program-prefix=progprefix inspired by automake. If the user
specifies --with-program-prefix=charybdis, the ircd binary is named
charybdisircd when installed.
Add support for saving the pidfile to a rundir and storing the ban
database in localstatedir instead of in sysconfdir. This is, again,
conditional on --enable-fhs-paths.
Fix(?) genssl.sh to always write created SSL key/certificate/dh
parameters to the sysconfdir specified during ./configure. The
previous behavior was to assume that the user ran genssl.sh after
ensuring that his current working directory was either sysconfdir or a
sibling directory of sysconfdir.
This becomes important because of away-notify sending aways to common
channels much like nick changes (which are also paced).
Marking as unaway is not limited (but obviously only does something if the
user was away before). To allow users to fix typos in away messages, two
aways are allowed in sequence if away has not been used recently.
